Analysis of tote bag printing needs attention

Since it is not possible to print a grip edge with a width of about 1cm on the printing paper, and there are rules and color codes outside the finished product range, for general printed parts, first cut the paper to a larger size than the finished product, then Process after printing. At that time, use a paper cutter or die cutter to cut off the surrounding waste paper.

If the creasing process for handbag printing is to use thick cardboard instead of creasing lines, then die-cutting and creasing should not be performed at the same time. Therefore, tote paper bags are usually processed only by creasing and not die cutting.

The sticking and folds on the sides may be a little narrower when the paper size is tight, and a little wider if the paper bag is large. The bottom of the paper bag is 0.5×b. Sticky bottom. The bottom rod is about 1 cm. If the paper bag is larger, it can be wider. Since it is not possible to print the gripping edges on printing paper with a width of 1cm, and there are rules and color codes outside the range of the finished product, for general printed parts, first cut the paper to a larger size than the finished product, and then Process after printing. At that time, use a paper cutter or die cutter to cut off the surrounding waste paper.

If the creasing process of the tote bag is to use thick cardboard instead of the creasing line, it should not be die-cutting and creasing at the same time. Therefore, paper bags are usually only indented rather than die cut.

If you need custom any paper bags paper box, please let me know, thank you!